The M-1828 Bayonet
in Pictures

The M-1828 bayonet was designed to be used with the M-1828 flintlock musket.  In the first two years of its manufacture a version of the bayonet was made with rounded edges, it has been supposed that these were made for training purposes.  During the 1830's a slightly shorter version of the bayonet was manufactured for use on the older M-1808 flintlock musket.  The weapon was later used with the M-1844 modified percussion musket, the M-1845 percussion musket, and finally the M-1847 percussion dragoon musket.

 

The Locking Ring

Here are two views of the locking ring system that was used to fasten the bayonet to the rifle.  Such systems were common during the early 19th century.  The three step slot and ring can be seen here.  It should be noted that the Russian army did not place serial numbers on bayonets until 1852.

 

The Bayonet Tip

The tip of the M-1828 bayonet tapers down to a sharp point.  Also visible here are the two fullers on the outer side of the blade.  The inner side of the blade is flat.

 

Bayonet Markings

This right picture shows what remains of the only markings on the bayonet.  This number '17' is either a factory or regimental marking.  There is also an illegible symbol above and below the number.

   

Other Views of the Bayonet

Here are three more views of the M-1828 bayonet.  The top picture you can see a close view of the arm connecting the spike of the bayonet to the mounting cylinder.

Below is a view of the bayonet showing the inner fuller and the marking on the weapon.  While the last picture shows how the bayonet looks when looking through the cylinder.

  
 The M-1828 Replaced... M-1828 Bayonet The M-1828 was replaced by...
M-1808 Bayonet M-1854 Bayonet

 

Back to M-1828
Bayonet Main Page